CAN Interface Installation

To use your new Allegro Hand with Allegro Application Studio (AAS), a controller area network (CAN) interface must be used. Out of the box, the Allegro Hand and AAS communicate via any of four CAN interface products:

  • National Instruments' (NI) USB-8473s High-Speed CAN
  • Softing's CAN-AC2-PCI
  • Kvaser's PCIcan 4xHS
  • ESD's CAN-PCI/266


All four of these CAN interface solutions can be purchased from SimLab along with the Allegro Hand.
Driver information and downloads can be found on our Getting Started page.
Note: Other CAN interfaces may also be used but communication must be configured by the user.






You are not allowed to post comments.




Copyright & Trademark Notice
Allegro, the Allegro logo, RoboticsLab, the RoboticsLab logo, and all related files and documentation are Copyright ⓒ 2008-2020 Wonik Robotics Co., Ltd. All rights reserved. RoboticsLab and Allegro are trademarks of Wonik Robotics. All other trademarks or registered trademarks mentioned are the properties of their respective owners.

Wonik Robotics's Allegro Hand is based on licensed technology developed by the Humanoid Robot Hand research group at the Korea Institute of Industrial Technology (KITECH).

Any references to the BHand Library or the Allegro Hand Motion and/or Grasping Library refer to a library of humanoid robotic hand grasping algorithms and motions developed and published by KITECH researchers.
J.-H. Bae, S.-W. Park, D. Kim, M.-H. Baeg, and S.-R. Oh, "A Grasp Strategy with the Geometric Centroid of a Groped Object Shape Derived from Contact Spots," Proc. of the 2012 IEEE Int. Conf. on Robotics and Automation (ICRA2012), pp. 3798-3804

Wiki maintained by Sean Yi <seanyi@wonikrobotics.com>

KitechLogo.jpg Wonikrobotics logo.png





Whos here now:   Members 0   Guests 0   Bots & Crawlers 1